Gadgetory

hey guys Wellington here in this video I'm going to show you how to use a brother printer to print on DVDs blu-rays and CDs I'll be using a brother printer MFC jh7 0dw now the process for some models might be a little bit different but the basics are all pretty much the same I use Neusoft CD level of software to design my DVDs and blu-rays and it comes with a printer so let's get started assuming you've already installed the software on your machine now let's go ahead and open it click start program and here you will see all these cool templates that you can edit to your taste but I've always used a blank template so I'm going to select that and click apply the Edit window will appear click level site settings to configure the level sites before you start your design process I like to keep the outer diameter all the way to the max in the inner diameter all the way to the minimum and that's because I like my DVD print covering the entire DVD like this but not like this one right here press ok and begin designing your label now this software has a really really easy layout so it's not hard to figure out where stuff is so I'm not going to go into details about the designing process because I'm pretty sure you can figure it out so when you're done with the design process and happy with the results click print select your machines name from the drop down menu in the dialog box and for the paper size select 12 centimeter disk in brackets 4.7 inch and click OK wait for a second for the software to communicate with your printer the machine will then prompt you to make sure there is at least 4 inches of space behind the machine and that's because when you're printing the print tray comes out the back of the printer at least 4 inches out so make sure there is more than 4 inches behind your machine and then click OK so now we leave the computer and go to the printer if the two are communicating properly the printer should be saying this on its display so if that's what you have let's go ahead open the scanner cover and remove the disk tray and finally place the printable disk onto the disc tray push and pull down the disc guide to open it insert the disc tray into the disc guide and make sure to line up the triangular marks on the disk tray and the disk guide and this is serious do not push the disc tray all the way into the disc guide if you do so it will get stuck inside press ok and the machine will start running and when it's done I usually wait for about 30 to 60 seconds and then remove the disk from the disk tray thanks for watching but I would really love to hear from you guys and what printer and updo you used to print your CD labels leave your comments down below and don't forget to subscribe to my channel like the video and I will see you in the next video