Gadgetory

One of the most important accessories you can ever buy for your phone is a tempered glass screen protector. The ones I sell are called Fire Shields. They have a lifetime warranty and are thin enough to work with any case. You can click the link in the lower left hand corner or check the video description for my website. Not only does a tempered glass screen protector protect your screen from scratches, it also helps your phone be more shatter resistant. A small investment now will extend the life of your device. Here’s the protector itself. You can see how thin it is. And I’m going to walk you through the super easy installation process. Here’s the little tab for a little protector that’s on the bottom side of the glass. Before you take that off, position the glass on top of your phone so you can see exactly where it needs to be for the final installation. You can take one of the cleaning pads, the dry or the wet, and make sure that there’s no dust on top of your screen, or smudges or fingerprints. I find that quick motions along the top will get rid of the smudges and fingerprints. And then long swipes from the top and the bottom will get rid of any of the dust specks on top of the screen; just like so. You can check with the glare of the light to make sure that there are no dust specks on top. Dust specks will be your worst enemy during the installation process. Take off the bottom glass protector. Then you can line the protector up with the top of your phone, judging the distance between the glass and the earpiece, as well as the sides of the device. You want to make sure that there’s an equal distance between the screen protector and each edge of the device. You can drop the protector down into place, and you can see that it will magically adhere to your screen. The nice thing about these protectors is that they will never leave any residue on your device. So if you ever need a warrantee replacement, you just lift it off and plop the new one on and you’re good to go. Take your finger and you can press it around the edge of the screen just to make sure that all of the edges are adhered to the device. Then you can clean it off with the remaining pad from your kit. Now, there is no dust under this protector but let’s pretend like I did get a dust speck underneath my screen. Now I’m going to teach you how to remove a dust speck after your screen has been installed. Here’s the little speck removing sticker. You can also use just a piece of clear tape if you would like as well. Grab a razor blade and slip it underneath one of the corners closest to the dust speck and you can see that it will lift up the screen protector a little bit. And slide your sticker, or piece of tape, in between the glass and the screen. If your dust speck is stuck to the protector, make sure the sticky side is up. If your dust speck is stuck to the screen, make sure that your sticky side is down. Basically you’re going to lift up the protector a little bit and grab the dust speck with the sticky side of the tape or sticker. Pretty straight forward. And then once you pull that dust speck out, remove the razor blade and the screen should magically adhere back to the phone again. Pretty sweet. If you have any questions make sure to leave them in the comments below. Don’t forget to “like” if this video helped you, and don’t forget to subscribe. Check out FireShields.com for the screen protectors. Thanks for watching!