Gadgetory

okay so we're listening to the sound that the Indian mountain makes so as we're accelerating it doesn't make any noise I'm but as soon as we let off the gas kind of makes that rattling noise up in the front there that's because when we're accelerating the engines putting out enough torque to kind of keep it in the same spot but as soon as we let off the gas it loses all the torque it has and so it starts to rattle around inside that mountain so you can kind of hear that alright so today we're going to place an engine amount on a 2000 Nissan Altima the engine mount itself is right here this yeah you can kind of see that it is torn up on the inside it's a hydraulic mount so it's not all solid rubber in there it's a rubber with a pressurized hydraulic fluid inside and it's been rattling around so what I've done so far is I took a jack and I just supported the engine just a little bit just enough to raise it up so when I take that mount off there's not a whole lot of pressure on it and then I can raise and lower the motor just a tiny bit to line it up when I get the new mount back on there so we had three bolts we had two right here and then one right underneath there and I was able to get that one right here by the alternator I just had to get one of these long wrenches and just kind of sneak it in there and wrench it out little by little I figure that's a lot easier than taking the alternator off then there's so those three right there and then there's one long bolt this guy right here that goes through the mount itself now there's a nut on one end other bolt 14 millimeters as well anyway that's the only thing holding the mount in there see how easy it is to take out now that I have the engine lift it up just a little bit you can see the inside of the mounts completely just shredded bits so all the hydraulic fluid used to the inside of that and I forgot the new mount right here so I'm going to put this little black box on top of the new mount right here and then just slip it in and kind of bolt everything back into place again and drop the engine so there's one more look at what the good mount looks like got the box mounted to the top this one was 100 bucks at my local auto place I'll Riley I'm pretty sure you can get them cheaper off Amazon though so I'll post a link at the bottom of the video for that and there you have it everything is all torqued down I believe these bolts should be around 4045 same thing with this bottom one just make sure it's super tight it's not high yeah just make sure it's super tight anyway that's about it make sure to LIKE if this helped you and don't forget to subscribe thanks