Gadgetory

The LG Viper LTE. Remove the back from the bottom. The battery…the SD card. Screws to be removed. Then remove the back of the phone. Carefully pry up the back. Don’t force anything. Speaker… Camera… Vibrator… Headset jack…. Cables. Pry up the connector here. It’s seated in the main board so be careful not to break anything. It has an attachment just underneath the board there. It will come off. There’s a connector there, and there. Then the connectors on the sides just open by itself...gently. Pull the board away. And you’ll have connectors by your speaker on there. So make sure to lift that up out of there. And then the cable attachments underneath the board. Rear facing camera…volume. The cable assembly for the touch screen and LCD. Everything else is going to be built kind of in the housing. You should be able to heat up and pry this off as well, to remove the digitizer. Adhesive. There’s your mic. Make sure your filter goes back in place. Reset your cable on the side. Make sure you plug your housing in again. Push it into place. Reset your speaker….cables. This goes back in there…oops…there. This will clasp back down. Then just replace your screws. Then replace your SD card…battery…back. And that’s all.