Gadgetory

so we have a new tire back you can see the tread on this one's a whole lot they're in the other one now we're going to put on the final drive I'm just kind of just pop it back in place I did grease up these these gears just a little bit I'm just kind of wiped off the old degrees threw on some new ones it's belt we're at right now make sure you toss some grease on the axle as well so as far as getting the wheel back up into place it's kind of a little dance you have to do to make sure everything lines up right I'm the first thing I do is I make sure this the shaft right here is lined up with this old and it cut you know Ang's that angles that way once that's in place here on this side you have to make sure that this is lined up correctly so it slips up over this notch then the caliper goes on and connects to this and once those are in place then you can start to angle the splines of that shaft on the other side into the engine itself and how you get it it's like exactly you saw on the other end of the splines there's kind of like little teeth to have to mesh in with the the other part of it so you kind of spin the engine out sorry you spin the wheel which turns that shaft right there which makes it so the splines line up so you kinda have to lift up twist it and push it in all the same time anyway so that's a that's the dance you have to do and now I'm just kind of putting out the bowls by hand making sure up everything lines up right and then once all the bolts are in and the tires in the right position I'll tighten them all down