Gadgetory

okay so they were going to install a Spitfire windscreen on a motorcycle basically it comes with a mounting hardware and then the windshield itself made out of plastic so to get this to screw out of the windshield you have to take this part right here put it up through the bottom and then put this washer on this stick this through the windshield put this on after that and then screw this on to the end you can kind of see over here on this one I have the plastic piece a washer the windshield the other washer of the black black piece and that holds this part in so once I have it all screwed on then I could put this through that little hole and then tighten this and then hold it all in one spot and this is what clamps on to the motorcycle handlebars so we are mounting it on the bike you can see I have that screen under the shield right here and then it's got the bar there going down I'm normally it's got this little connector right here that'll sit this part will clamp onto the the bar right here then you screw this bolt down to tighten it on this particular bike though this these bars are too big so I had to do some as I ended up getting a piece of conduit at the conduit hanger and it clamps on over the bars and this just clamps around that I'm gonna see how that works and I put just a little piece of rubber stripping in there to kind of protect the chrome on the bike that's the piece that I bought anyway so it looks like it's gonna hold on really well I'm gonna grab another another one for the other side and we're good to go so a nice thing about this windshield is that if you just unscrew these right here and pop this out these two bars come up off the top so you can literally take the windshield off and probably thirty seconds there you go scout both those hangers on it right now just purse all right take off that red sticker on the bottom as well anyway if you have any questions freely them in the comments make sure like if this helped you and don't forget to subscribe you