Gadgetory

so today we're going to take apart the ZTE theory from Sprint to start off with their seven screws going around the outside to speed this up so come to watch me taking off each one one of the screws is underneath that little sticker is the void sticker just you know like taking apart the foam and stuff your board all the manufacturers warranties but it's a pretty simple process you shouldn't have too many problems to start unequipping the screen from the frame I started at the bottom of it and you can see as I take my pry tool and just kind of slide it along the edge here there's probably got four clips on either side and then a few on the top and the bottom that snap open they separate oh right where the color meets the silver you when you pull the two pieces apart make sure you make sure the motherboard stays down on the top of it next to the screen and doesn't pull away with the bottom half of the phone as you can see all of the different components of this phone are soldered onto the board so there's really nothing else that you can replace without getting super technical into the soldering aspect and there's three ribbon cables attached to the screen the bottom line is stayed by the battery in this one right here that goes to the screen and then this one right here by the top basically just take the little tiny clip and slip it up flip it up right along the edge and then you wiggle the the ribbon cable out very gently from the edge and they are pretty you know resilient so you shouldn't have too many problems you know ripping them or carrying there anything as long as you're fairly gentle there's no screws holding the motherboard down so just pull it away this is the whole screen putting it back together the motherboard does kind of clip into place not clip so much but it sits really firmly between the screw holes back into place that was one of the hardest parts getting into lino so in theand just be gentle with them and then once a goes all the way inside of the little holster for it you can slide down the little latch which locks it all into place the back plastic itself just clips right back on again make sure you run your hands at both sides make sure all the latches are in place then you can take all the screws and put them back in any latches that you miss like any clips that didn't clip into place will clip into place once we get the screws inside toss the batter you're good to go and you know I do post lots of phone you know tear down rebuild videos at least once a week so go ahead and like if this helped you and don't forget to subscribe thanks