Gadgetory

so my name is hemant metha I am from anoxia the German brand we are doing PC cases and today we are on CES show and we are representing representing our case on the Swiss tech booth so at first I'd like to introduce with the case it's generally it's a more isolated case which is completely sealed with gentle material inside so we just start with the phone in the front you got a upper door it's got noise isolation form on top you go three times can't control with that bottom of course and is easy to have any closings for the OD d slot this can be closed thank you on the lower area we got two sets of fan oldest which can be opened easily and here you got some cast filters inside which can be taken out as well you can easily remove the fans you got two friends in front of the case right out of the box close it like this close it again and then you can simply close the door inside the case we got this car destroyed cages you can easily remove the other ones of these bowls to get better airflow through the chasis and you can unscrew it this one the one on the bottom if you unscrew this one you can attach a 240 millimeter Fender radiator in front of the case these are the drawers which are vibration isolated as well and it's fit to 23.5 in 2.5 drives you've got two or three full 5.25 OD d bays and this is detached now but normally we got a slider here that means if you take off this this cages to mount the radiator right behind the intake fans you can add the hardest K is here one-by-one to stock up like maybe four five or six harddrive this depends of course of the space you got here away from the motherboard you can also attach a radiator and front of cap on the case like the people from terrific ed here you see we got a set of different mounting holes through it you can attach a fan tooth count to fans of 120 or 140 millimeter fans on top all this radiator like here and as you can see you got a lot of space left so you don't have any incompatibility issues with the motherboard the hundred forty millimeter fan on the in the back side there's also stock fan also controlled by the fan controller which is provided right out of the box you got eight times PCI slots and the width of the case and total is 220 millimeter I'm talking about the unique feature we called the air chimney that means to have a leave design a clean design it's closed like this but if you like to attach fans or if you'd like to add in variator you can open it easily by sliding like this and also the i/o panel can be attached or just put just pushing it can also be easily closed like this again yeah on the back you can see now we got this this grommet - just to add some tubes inside and in case you like to have an external external components for your water cooling stuff but it's also included this close rubbers to cover it here so it will be closed later on and we got enough space for cable management beside this side tray which is a side panel which we can show as well and this is a kind of additional possibility to to get the air out or intake air intake even if it's closed here on top so every unscrew the side panel and take it off you can show you easily there's enough space to start the stapler the K rates even if you got a large amount of cables to get everything in order and here you can see the panel got some be tuning for noise isolation against the vibration and the noise in total this is the case we developed for nearly a year and it's available in Europe since October in 2012 and this will be available in the United States mid of February approximately